The Nighthawk Microlight II - the powerful little light you can wear on your finger or clip to a hat!

All you do is attach the Velcro strap to any finger of either hand. Slide Velcro Strap through slit in unit (you can do this with or without accessory clip in place). Then feed the small end of the Velcro Strap through the notch in the other end of strap. Pull tight to adjust for comfortable fit. If necessary Velcro Strap can be cut to size for easier use.

*On/Off switch is located on top of unit. Push for On, reverse for Off.

*Your Nighthawk Microlight II comes equipped and already installed with Two (2) 1.5 Volt #357 button batteries.

Features:

• Measures only 1.5" x 3/4" with finger Velcro, or 1.5" x 1" with clip.
• 9000 milli candela high intensity LED light.
• Weighs less than .05 oz!
• 15 PLUS hours of continuous use on a set of alkaline button cell batteries.
• Comes with an accessory clip for caps and hats.
• High impact plastic construction. It's weatherproof!
• Lifetime Guarantee.

*To replace batteries open rear access cap by turning 1/8 turn counter clockwise. Be sure to ALWAYS Replace batteries with the (+) side UP. Installing batteries incorrectly can lead to unit failure which is not covered by warranty. Close rear access cap by aligning with grooves of unit and turning 1/8 turn clockwise.

*To remove/attach accessory clip/Velcro Strap remove battery cap (as described above) and slide clip/strap into place. You can use the unit with the clip in place or with the clip removed.

*All parts and workmanship are 100% guaranteed for the life of the product.